Time dependent temperature under ansys...
Time dependent temperature under ansys...
(OP)
Hi everybody,
i'm a "new born" engineer, i work under ansys and i don't manage to apply a time-dependent temperature on my model.
I would like to simulate a cooling from 800 to 100 °C with a velocity of 4°C per minute, and then a free cooling until 20°C (room temperature).
Which commands must i use to do so ?
Thanks in advance for all your help.
Jeremy
i'm a "new born" engineer, i work under ansys and i don't manage to apply a time-dependent temperature on my model.
I would like to simulate a cooling from 800 to 100 °C with a velocity of 4°C per minute, and then a free cooling until 20°C (room temperature).
Which commands must i use to do so ?
Thanks in advance for all your help.
Jeremy





RE: Time dependent temperature under ansys...
I would try a full transient analysis. Look at these commands in the ansys help:
antype
time
deltim
kbc
autots
ic
Also look at the "Chapter 5. Transient Dynamic Analysis" in the ansys help.
Regards,
Alex