Offset face in Catia
Offset face in Catia
(OP)
Hi All,
Just wondering if there exists a feature in Catia that is similar to "offset face" feature in UG. I have tried "thick surface" but that seems to only add mat'l, I want to do a negative offset so that I remove mat'l. Any suggestions?
Thanks,thixoguy
Just wondering if there exists a feature in Catia that is similar to "offset face" feature in UG. I have tried "thick surface" but that seems to only add mat'l, I want to do a negative offset so that I remove mat'l. Any suggestions?
Thanks,thixoguy





RE: Offset face in Catia
RE: Offset face in Catia
You can pocket a solid using a non-planar face, and a specified direction. (plane, line, or linear edge)
---
Professional and reliable CAD design engineering services - Specializing in Catia V4, Catia V5, and CAD Translation. Catia V5 resources - CATBlog