Meshed Parts into an assembly?
Meshed Parts into an assembly?
(OP)
Is it possible to mesh two or more parts individually, then put them in an assembly and run a frequency analysis without having to re-mesh?. My PC is struggling to mesh the model as one part due to 'mesh and volume sizes being significantly different'! But through-out the study I have been able to mesh smaller parts.






RE: Meshed Parts into an assembly?
no, at least not up to version 2005. Perhaps v.2006 has improvements in this, but I believe not, due to the manner in which C/Works works.
Regards
RE: Meshed Parts into an assembly?