Need Post file for NX3
Need Post file for NX3
(OP)
Hello everyone, just starting in NX3. Im moving from Mastercam 9 and x to nx3 because of my company i work for is changing over. So, Im tring to get aquainted with NX3 and doing good so far. I do need to make sure that what I produce in Code for the CNC Centers in the shop looks as much as possible to what has been created in the recent past. My biggest worry is the post processor file. I need multiple work offsets and subs. Any sugestions where to start?





RE: Need Post file for NX3
I would heavily suggest you take the Postbuilding class.
UGS also has a section where you can download posts. I don't know how close they are, I built my own.
I would think, also being a Mastercam user, that getting ALL of your output to look like an MC is not going to happen. The code will work and you may get it close but in the end you'll have differences.
You will need a Webkey account to access the UGB bbs and file download areas.
HTH
RE: Need Post file for NX3
RE: Need Post file for NX3
--
Bill
RE: Need Post file for NX3