Wrapping. Trouble creating the continuous surface.
Wrapping. Trouble creating the continuous surface.
(OP)
I'm attempting to wrap a sketch around an object but my surface needs to be continuous. I've attempted extruding a sketch with lines and curves, but this doesn't give me a that contiuous. I ended up fitting a spline and extruding it but it would seem to me there is an easier way. Is there a way to convert sketch entities(lines & curves) into a spline?






RE: Wrapping. Trouble creating the continuous surface.
Helpful SW websites FAQ559-520
How to get answers to your SW questions FAQ559-1091
RE: Wrapping. Trouble creating the continuous surface.
Also, do you mean you want the wrapped sketch to be continuous?
Helpful SW websites FAQ559-520
How to get answers to your SW questions FAQ559-1091