Fanuc OM
Fanuc OM
(OP)
I would like to know how to send Macro files(O9000-O9999)into controler. Which parameter must be change to allow transmition? Thanks majstr
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
|
RE: Fanuc OM
Are you talking about up loading those files to the control?
I don't remember all the specifics but, I remember when
I had a problem with something like that I'd just call the
file something else and then change the program number to
what you want after its sent.
You may have to just call Fanuc.
RE: Fanuc OM
RE: Fanuc OM
But for argument sake, say type "A" is what any Fanuc control can read with out anything special. But with type B
it has to have a special card or software to see it.
I ran into a machine at a place I worked at, that had a tool setter on it that had not worked since the day they got it new. And they never used it. I don't even think they knew it was a tool setter. I made it my project to get it working. The factory macro was type B and it always alarmed don't remember the number, but it is program not found.
I figured out that the machine did not have the special card or what ever to use that macro, so I wrote one similar but with more features in the type A. Don't know but could be your problem also. Also in the settings table, I think there is a place to turn on for macro's. Have you paged through the parameter pages looking for anything labeled as macro? What you need is a good book on the control. I would contact the machine manufacture and get those parameters from them.
RE: Fanuc OM
that may have an answer for you.
http://www.cnczone.com
RE: Fanuc OM
to write or protect
RE: Fanuc OM