Blended Radius
Blended Radius
(OP)
Is there a proper method for dimensioning a blended radius? My part has a 3mm radius about the perimeter that blends down to 1mm at the mounting locations. Other than putting a leader on the drawing stating "blended radius" is there a better way to do this? 14.5 doesn't seem to cover this. In this situation I'm not too worried because I'll be sending the math model to the shop but I am curious as to the proper way to do this. Any thoughts?
Bsilk
Senior Designer





RE: Blended Radius
R3MAX BLENDED R1MIN
but this is from company standard not ISO...
RE: Blended Radius
Chris
Systems Analyst, I.S.
SolidWorks/PDMWorks 05
AutoCAD 05
ctopher's home site (updated 06-21-05)
FAQ559-1100
FAQ559-716