Hatch - "Gravel" pattern error
Hatch - "Gravel" pattern error
(OP)
I have a large drawing of a building with a lot of detail. The drawing was drawn in milimeters. When I hatch a 6" area showing gravel under a slab, it is displayed as a bunch of straight lines all over the place. It doesn't look like the gravel hatch at all.
Is this some sort of error? Is there a way to correct this?
Is this some sort of error? Is there a way to correct this?





RE: Hatch - "Gravel" pattern error
ADT 2004
ACAD 2002
RE: Hatch - "Gravel" pattern error