Printing issue
Printing issue
(OP)
We just upgraded to SolidWorks 2006 SP3 from 2005 SP2.0. We are now noticing D and B size prints on our HP 1050c are getting clipped at the edge of the drawing. I tried changing the paper sizes (22X34, oversized ANSI D) and noticed a slight improvement with the 22X34 paper size. This has never happened befoere and has only started since we installed 2006. Has anyone else seen this? Have a fix? We are currently creating custom paper sizes, as the printer is a roll feed printer. We are hoping the custom paper size will give us enough so that the edge of the drawing isn't clipped off.
Pete
Pete






RE: Printing issue
Regards,
Scott Baugh, CSWP
www.scottjbaugh.com
FAQ731-376