Linking a drawing table to a property in the model
Linking a drawing table to a property in the model
(OP)
Say you have a standard internal gear in the model,
is it possible to link, say the number of teeth, to a table in the drawing?
It's gotta be. I know you can link document properties relatively little problem.
SW 2006, SP 3.0
is it possible to link, say the number of teeth, to a table in the drawing?
It's gotta be. I know you can link document properties relatively little problem.
SW 2006, SP 3.0






RE: Linking a drawing table to a property in the model
Helpful SW websites FAQ559-520
How to get answers to your SW questions FAQ559-1091
RE: Linking a drawing table to a property in the model
Easy as pie - I just don't have a whole lot of 'Design Table' experience.