adding quantity to drafting sheet
adding quantity to drafting sheet
(OP)
The quantity is on the layout drafting sheet in the B.O.M. But my company wants the quantity to show up on the individual drafting sheets. I can get the quantity to show up on the drafting sheet but it is always 1. Is there any way to get it to reference the layout BOM?





RE: adding quantity to drafting sheet
The quantity of any individual part drawing will always be one.
What if you use the part in more than one assembly ?
Unless the quantities are always the same it's pointless putting it on the detail drawing.
bc
RE: adding quantity to drafting sheet
RE: adding quantity to drafting sheet
It would be embarrising if you wanted a single replacement part and drawing had quantity of 1000.