×
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS

Log In

Come Join Us!

Are you an
Engineering professional?
Join Eng-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Jobs

Sear Key
2

Sear Key

Sear Key

(OP)
The question is regarding functioning of shear key used in the footings. I have a square footing (8'x8') with a large horizontal force acting on it and it fails in sliding. To help resist in sliding, I decided to put a shear key 2'x1.5' at the bottom of the footing. Now, to resist sliding, there is a frictional resistance force 'mu*summation of all vertical forces including the weight of soil and concrete', the passive pressure of soil acting at the back of the shear key and also the depth of the footing. Is the shear key itself capable of resisting some of the horizontal forces say by use of shear stirrups?
I am looking forward to your comments.

Thanks,

Robert

RE: Sear Key

Are you asking about designing the reinforcement for the shear key, or how the shear key helps resist sliding forces?

The shear key increases your depth for developing passive presure resistance to sliding.  You will have a linearly varying force on the face of the shear key itself, causing and internal bending moment and shear force.  Both of the must be accounted for when you design the thickness and reinforcement of the shear key.  Keep in mind that this is a footing, basically a hole in the ground.  You shouldn't try to get too precise by adding too much steel that isn't normally found in a typical footing.  You're better off increasing the thickness of the key to resist shear so that you won't need stirrups.  You will likely need some reinforcing, if only minimum, to resist the bending moment in the key.


It looks like you got the point of providing a key, but your question isn't quite clear on what you mean, to me anyway.  Stirrups will help with internal forces induced by the external sliding force, not with the sliding force itself.  Hope this helps

RE: Sear Key

Shear Keys dug in soil sound alot better than they truly are. The main reason is that when the key is dug out by hand lets say, that process disturbs the sides of the soil thus your passive pressure may not be as good as you typically would design it. While the key clearly helps reinforced as you are designing, it may take a lot sliding from the footing to occur to actually mobilize the passive pressure benefit a situation you do not want to happen. What is your column load and what type of soil friction factor are you using?? Do you have a concrete slab over the footing?? I would use a key only under a special inspection requirement during the excavation of the key and the pouring of the spread footing, otherwise I would not count on it. Hope this helps. Good Luck.

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Eng-Tips Forums free from inappropriate posts.
The Eng-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Eng-Tips forums is a member-only feature.

Click Here to join Eng-Tips and talk with other members!


Resources