×
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS

Log In

Come Join Us!

Are you an
Engineering professional?
Join Eng-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Jobs

Weirs

Weirs

(OP)
Does anyone know of a reference which discusses the use of weirs in outlet control structures for detention basins?  I am looking for a practical explanation of when to use different types of weirs, dos and don'ts, etc.

RE: Weirs

You should be able to check the DOT site for your state.  They have lots of information on drainage control.

RE: Weirs

Use weirs for situations where you need moderate to high flows with low head requirements.  Use orifices for smaller flows.  Very small weirs tend to get clogged.  I would read Debo's "Municipal Stormwater Mgt."  

RE: Weirs

Open-Channel Hydraulics by Chow is a classic reference on weirs (and other hydraulic design elements).  The fact that it's in a pond means your approach velocities will be essentially zero.

Uncivilized hit it dead-on regarding when to use weirs vs orifices.  You cannot obtain precise low-flow control with a weir, but can accomodate high flow with low head.

Also note that an overflow riser operates as a weir under low stage conditions, but starts to operate as an orifice as the stage increases.

Check your DOT or Drainage Utility's manuals for guidance first, if what you need is not in there consider checking out Chow.

RE: Weirs

(OP)
What about sharp-crested v. broad v. v-notch in detention basins?  Any practical experience?

RE: Weirs

Generally, overflow spillways are modeled as broad-crested whereas an overflow riser, weir plate or other "structural" weir (wood, metal, conc) less than say 12"/300mm would be sharp-crested.

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Eng-Tips Forums free from inappropriate posts.
The Eng-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Eng-Tips forums is a member-only feature.

Click Here to join Eng-Tips and talk with other members!


Resources