how to fix errors?
how to fix errors?
(OP)
While changing one dimension of a part I got into an error.
The problem is that apparently there is no way to go back: if I right click to delete/edit the component, or any other component I can't get anything. Apparently the only way to proceed is to start from scratch, creating cascades of errors in all the related assemblies.
What to do?
thanks in advance.
The problem is that apparently there is no way to go back: if I right click to delete/edit the component, or any other component I can't get anything. Apparently the only way to proceed is to start from scratch, creating cascades of errors in all the related assemblies.
What to do?
thanks in advance.






RE: how to fix errors?
Regards,
Scott Baugh, CSWP
www.scottjbaugh.com
FAQ731-376