Simple Model
Simple Model
(OP)
Simple solution - I know it. Could do it by hand in 30 minutes - maybe less. It's a simple - force applied, can structure withstand the load.
Since, I got it secondhand, I'm thinking there are some issues in the model. What are some things I need to keep an eye on?
Since, I got it secondhand, I'm thinking there are some issues in the model. What are some things I need to keep an eye on?






RE: Simple Model
What type of model is it?
parasolid
surface
SW native
Part
assembly
"I think there is a world market for maybe five computers."
Thomas Watson, chairman of IBM, 1943.
Have you read FAQ731-376 to make the best use of Eng-Tips Forums?
RE: Simple Model
Problem: 600 lb solid cube (not centered) sitting on a flat piece of steel , approximately .125 inches thick, which (that piece of steel) is resting on a rack, approximately 3/4 of an inch off the ground. This rack consists of four supports which hold up the piece of steel, and holds the rack together in a rectangular-type shape.
I'm not necessarily looking for a solution, but perhaps a method. (I've guessed that the problem isn't so much with my method, but maybe the model I inherited has a bug or two in it. But I'm open to any suggestion.)
RE: Simple Model
"I think there is a world market for maybe five computers."
Thomas Watson, chairman of IBM, 1943.
Have you read FAQ731-376 to make the best use of Eng-Tips Forums?
RE: Simple Model
except now, I'm not sure how to demonstrate a non-linear remote load, to my model. Or, from what I've described, does that sound like a non-linear remote load, anyway?
RE: Simple Model
"I think there is a world market for maybe five computers."
Thomas Watson, chairman of IBM, 1943.
Have you read FAQ731-376 to make the best use of Eng-Tips Forums?
RE: Simple Model
RE: Simple Model
You should post your upgrade problem in forum559 as it is a different topic than this one.
"I think there is a world market for maybe five computers."
Thomas Watson, chairman of IBM, 1943.
Have you read FAQ731-376 to make the best use of Eng-Tips Forums?