Macros in Protel 99SE and Altium Designer
Macros in Protel 99SE and Altium Designer
(OP)
I am trying to write a mcro in Protel 99SE and the latest version of Altium Designer but I am hopelessly stuck.
I need to be able to get Pick & Place information and well as PCB diensions and also to be able to find and change the 0,0 point aswell as to find any fiducials that there might be on the PCB.
Can anyone tell me if this is possible?
I need to be able to get Pick & Place information and well as PCB diensions and also to be able to find and change the 0,0 point aswell as to find any fiducials that there might be on the PCB.
Can anyone tell me if this is possible?




