How to switch fixed parts in an assembly?
How to switch fixed parts in an assembly?
(OP)
Hello everyone
Another issue - I inserted Part A & B into an assembly. Part A was inserted first, so it got fixed. Part B was created in-context of Part A. But now I want to make Part B fixed. I want to do this because once I have created Part B in context of Part A, I want to tilt Part A at an angle which can't be done since it's fixed. Is this doable?
Thanks
Another issue - I inserted Part A & B into an assembly. Part A was inserted first, so it got fixed. Part B was created in-context of Part A. But now I want to make Part B fixed. I want to do this because once I have created Part B in context of Part A, I want to tilt Part A at an angle which can't be done since it's fixed. Is this doable?
Thanks






RE: How to switch fixed parts in an assembly?
"I think there is a world market for maybe five computers."
Thomas Watson, chairman of IBM, 1943.
Have you read FAQ731-376 to make the best use of Eng-Tips Forums?