interfacing ni-DAQmx 6008 with labview
interfacing ni-DAQmx 6008 with labview
(OP)
Hi!
I have a signal generated in labview that I'm trying to send to an FPGA via NI-DAQmx USB-6008. I've been researching; however, all the examples seem to indicate that this device is for taking measurements. I don't need to take any measurements, just to have a vi to recognize the device and to send data out from it's parallel port. Any suggestions or advice is greatly appreciated.
I have a signal generated in labview that I'm trying to send to an FPGA via NI-DAQmx USB-6008. I've been researching; however, all the examples seem to indicate that this device is for taking measurements. I don't need to take any measurements, just to have a vi to recognize the device and to send data out from it's parallel port. Any suggestions or advice is greatly appreciated.





RE: interfacing ni-DAQmx 6008 with labview
Wheels within wheels / In a spiral array
A pattern so grand / And complex
Time after time / We lose sight of the way
Our causes can't see / Their effects.