Q-slice mode
Q-slice mode
(OP)
Hello,
I am making some simulations with Ansys and now I want to get the results in a slice that cuts my strucuture in two halfs.
Does anyone know how to do that?
Thnk you very much,
Maraia
I am making some simulations with Ansys and now I want to get the results in a slice that cuts my strucuture in two halfs.
Does anyone know how to do that?
Thnk you very much,
Maraia





RE: Q-slice mode
You can use these commands:
/TYPE,1,8
/CPLANE, 1 ! The working plane is the cutting plane
Reposition the Working plane at the desired position. (WPROTA, WPOFFS)
See also "12.4. Q-Slice Techniques" in the Ansys User Manual.
Regards
Alex