Dimensioning to a quadrant in .idw
Dimensioning to a quadrant in .idw
(OP)
Hi all, I'm new.
I've designed an spherical radius into a axially symetric part. I need to dimension the center of my spherical radius in a full section view, but Inventor won't let me pick it. Is there a clean way to do this?
Thanks!
I've designed an spherical radius into a axially symetric part. I need to dimension the center of my spherical radius in a full section view, but Inventor won't let me pick it. Is there a clean way to do this?
Thanks!





RE: Dimensioning to a quadrant in .idw