Partial sections in drawings
Partial sections in drawings
(OP)
I have had a problem with a drawing file created in version 2005 that has a partial section view in it.
When opening the drawing in version 2006 sp0.0 the section view comes in showing an overall view without the section. The view is shown dangling. I recreated the section using version 2006. The next time I opened that drawing, Solidworks crashed. (Then the email reporting kicked in.)
Has anyone else had this problem?
Tom S.
When opening the drawing in version 2006 sp0.0 the section view comes in showing an overall view without the section. The view is shown dangling. I recreated the section using version 2006. The next time I opened that drawing, Solidworks crashed. (Then the email reporting kicked in.)
Has anyone else had this problem?
Tom S.






RE: Partial sections in drawings
Flores
SW 2005 SP 4.0
RE: Partial sections in drawings
Tom S.