NX3 Question
NX3 Question
(OP)
Hi folks
In drafting when I switch between a 2D draw space to 3D using the display sheet icon in the drawing layout toolbar, if I put any kind of text in, using the annotation editor in a 3 dimensional draw space some where on a model that I have been working on, I’ll find that every time I switch between modeling, drafting and manufacturing I lose the text somewhere.
Anyone knows, why this might happen.
Thank all
In drafting when I switch between a 2D draw space to 3D using the display sheet icon in the drawing layout toolbar, if I put any kind of text in, using the annotation editor in a 3 dimensional draw space some where on a model that I have been working on, I’ll find that every time I switch between modeling, drafting and manufacturing I lose the text somewhere.
Anyone knows, why this might happen.
Thank all





RE: NX3 Question
RE: NX3 Question
Most folks have a grip routine handy to convert entities back and forth between 'model' and 'view dependent'. However, you may want to try this: <Edit> <View> <View Dependent> ...click the items to convert, and then click the icon (middle-ish of the dialog box) for converting from model to view dependent (or vise versa). Hope this helps...
SS
RE: NX3 Question
RE: NX3 Question