NX3 Post Processor
NX3 Post Processor
(OP)
Hello Everybody,
I am facing problems with NX3 postprocessor.The problem is that while using nx3 postporcessor some circular engage moves comes out straight lines but if I use same file and use GPM then it comes exactly as in part file.I don't know why is that.Anyone know how to solve this problem.I can send part file and post files if somebody wants to try. Thanxs,
Sekhon
I am facing problems with NX3 postprocessor.The problem is that while using nx3 postporcessor some circular engage moves comes out straight lines but if I use same file and use GPM then it comes exactly as in part file.I don't know why is that.Anyone know how to solve this problem.I can send part file and post files if somebody wants to try. Thanxs,
Sekhon





RE: NX3 Post Processor
RE: NX3 Post Processor
RE: NX3 Post Processor
RE: NX3 Post Processor
I am using nx3 postbuilder version 3.2.1
sekhon
xxx
RE: NX3 Post Processor
I am using nx2 and postbuilder 3.4.1 I have a post built
for an older Matsuura 5 axis vertical. What I need to do is build backlash moves into the rotations of B and C axis
only. Has anyone tried this?
Ginz