Fasteners
Fasteners
(OP)
We use the Solidworks toolbox to insert our fasteners. My question is, when we do that what is the best way to ensure the fasteners are always there after moving the files around on our network? Is it best to make a copy of the fastener and save it with the other files in the assembly?
Mechanical Engineer
Colmek Systems Engineering
Salt Lake City, UT
--------------------------
l l
0]lllll[0
l__l l__l






RE: Fasteners
RE: Fasteners
Mechanical Engineer
Colmek Systems Engineering
Salt Lake City, UT
--------------------------
l l
0]lllll[0
l__l l__l
RE: Fasteners
the toolbox.ini file points to where you have installed TB at. If that that file isn't pointing to the server then you see below
C:\Program Files\SolidWorks\Toolbox\toolbox.ini
There is no way to determine if it was installed, unless you know who installed it or talk to your IT dept.
Regards,
Scott Baugh, CSWP
www.scottjbaugh.com
FAQ731-376
RE: Fasteners