Can V5 drafting set the depth of a section view?
Can V5 drafting set the depth of a section view?
(OP)
How does one set the depth of a section view so that the view doesn't show/project the part behind a given plane? In old V4-auxview2, it was called back-clipping. It was nice for long parts such as aircraft spars when showing a stiffener features without everything behind it.





RE: Can V5 drafting set the depth of a section view?
RE: Can V5 drafting set the depth of a section view?
http://
RE: Can V5 drafting set the depth of a section view?