Solidworks on a MAC (apple)
Solidworks on a MAC (apple)
(OP)
I am running SW on an IBM T40. My lease is up at the end of the year, and the bossman says I can't replace it. Not sure why. Anyway, I wouldn't mind having a Powerbook, but I'm not too sure I can run SW, even using Virtual PC. Anyone know of any success stories.






RE: Solidworks on a MAC (apple)
"I think there is a world market for maybe five computers."
Thomas Watson, chairman of IBM, 1943.
Have you read FAQ731-376 to make the best use of Eng-Tips Forums?
RE: Solidworks on a MAC (apple)
RE: Solidworks on a MAC (apple)
M70 is much more powerful then the M20. I tested them side by side in Orlando and the M70 ran better then the M20... IMO
Regards,
Scott Baugh, CSWP
www.scottjbaugh.com
FAQ731-376
RE: Solidworks on a MAC (apple)
RE: Solidworks on a MAC (apple)
Search in this Forum, there are tons of previous topics that discuss this in greater detail, but the most important thing (notebook or desktop) is to have a graphics card that is certified for use with SW (check the SW website).
"I think there is a world market for maybe five computers."
Thomas Watson, chairman of IBM, 1943.
Have you read FAQ731-376 to make the best use of Eng-Tips Forums?
RE: Solidworks on a MAC (apple)
I went thru the forum quite a ways, but still am not getting solid results. Has anyone laid out the comparisons between a Dell, IBM, or any other system in a laptop??
RE: Solidworks on a MAC (apple)
Try my website as well.
Regards,
Scott Baugh, CSWP
www.scottjbaugh.com
FAQ731-376