NX2 - Changing part attributes from within assembly
NX2 - Changing part attributes from within assembly
(OP)
Hi !
Freshly working in NX2, I note that I cannot change component attributes from within my assembly. Only have access when make the component displayed ...
Is there any setting to activate an all levels access ?
Thanks
Freshly working in NX2, I note that I cannot change component attributes from within my assembly. Only have access when make the component displayed ...
Is there any setting to activate an all levels access ?
Thanks





RE: NX2 - Changing part attributes from within assembly
"Wildfires are dangerous, hard to control, and economically catastrophic."
"Fixed in the next release" should replace "Product First" as the PTC slogan.
Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand
RE: NX2 - Changing part attributes from within assembly
This is especially usefull when working in Drawings.
Michael
RE: NX2 - Changing part attributes from within assembly
I tried to change properties in NX2 as u described, but it did not let me do it.
good57morning@netzero.com
RE: NX2 - Changing part attributes from within assembly