nex new problem with Join
nex new problem with Join
(OP)
Now I am having problems with the join command. I have three separate parts that I am joining into one. I am able to select each of the three parts to join and then hit the check box. Although this worked fine on Friday, today one of the three bodies in the join part is not shown in the graphics window. I've tried to edit definition but it shows the body is already included in the feature selection, I just cannot see it. How can I fix this? Thanks again.
-todd
-todd






RE: nex new problem with Join
Regards,
Scott Baugh, CSWP
3DVision Technologies
www.3dvisiontech.com
www.scottjbaugh.com
FAQ731-376
RE: nex new problem with Join
-todd