Baseplate Design - Poles
Baseplate Design - Poles
(OP)
Hello,
I would like to know how to design a baseplate for a steel floodlighting pole. In particular, a baseplate that goes through the pole and is fillet welded top and bottom. How are the stresses transferred through the baseplate to the pole ? What effect does the hole in the baseplate have ?
References to any articles or text books would be greatly appreciated.
Regards.
I would like to know how to design a baseplate for a steel floodlighting pole. In particular, a baseplate that goes through the pole and is fillet welded top and bottom. How are the stresses transferred through the baseplate to the pole ? What effect does the hole in the baseplate have ?
References to any articles or text books would be greatly appreciated.
Regards.






RE: Baseplate Design - Poles
Formulas for Stress, Strain and Structural Matrices
Pilkey
Wiley Interscience
I ported the procedure to Mathcad 2000 Pro as well, freely downloadable from the Collaboratory site.
A filled weld has specific formulations for any layout, sometimes simplified to 1 or 2 formulations. Of course if you may need gusset plates to have a less thick baseplate.