Modal analysis for piezoelectrics
Modal analysis for piezoelectrics
(OP)
Hello everybody,
I am a beginner in ANSYS. I am doing a Modal Analysis for piezoelectric actuator. I have a stack of discs of piezoelectric material located between 2 steel plates. I apply zero voltage at each interfase of piezoelectric discs. I need to determine resonance frequency and anti-resonance frequency. When I run the solution I can get frequencies for several modes (POST1). How I can identify resonance and anti-resonance frequencies.
Thanks
I am a beginner in ANSYS. I am doing a Modal Analysis for piezoelectric actuator. I have a stack of discs of piezoelectric material located between 2 steel plates. I apply zero voltage at each interfase of piezoelectric discs. I need to determine resonance frequency and anti-resonance frequency. When I run the solution I can get frequencies for several modes (POST1). How I can identify resonance and anti-resonance frequencies.
Thanks





RE: Modal analysis for piezoelectrics
/post1
file,<jobname>,rst
set,list
VM175 ("Natural Frequency of a Piezoelectric Transducer") has an example of this.
Cheers,
-- drej --
------------
See FAQ569-1083 for details on how to make best use of Eng-Tips.com