Modal analysis - exceeding node limitation
Modal analysis - exceeding node limitation
(OP)
Hi Everyone,
I am trying to run a modal analysis on a 3D structure, however, when I refine my mesh I exceed the node limitation on the software (University edition). My model is symmetric about one axis, so is there a way to run a modal analysis on half the structure? Is this possible in dynamic simulations?
Thanks,
icefea
I am trying to run a modal analysis on a 3D structure, however, when I refine my mesh I exceed the node limitation on the software (University edition). My model is symmetric about one axis, so is there a way to run a modal analysis on half the structure? Is this possible in dynamic simulations?
Thanks,
icefea





RE: Modal analysis - exceeding node limitation
------------
See FAQ569-1083 for details on how to make best use of Eng-Tips.com
RE: Modal analysis - exceeding node limitation
Regards,
icefea