Manufacturing the body of Gas flow measuring turbine meters from GGG40
Manufacturing the body of Gas flow measuring turbine meters from GGG40
(OP)
Is it recommended to construct the body of natural gas measuring turbine meters (of size 4"/150 flanged G = 400)from the Ductile Cast Iron (GGG 40.3)?
If so what is the Standard follwoed or exact definitions of the material ?
What does 40.3 mean ?
What is the other coating / painting recommendations that must be followed ?
The turbine meter will be subject to direct wether conditions (outdoor installation).
If so what is the Standard follwoed or exact definitions of the material ?
What does 40.3 mean ?
What is the other coating / painting recommendations that must be followed ?
The turbine meter will be subject to direct wether conditions (outdoor installation).




