Opening cgr file in SW
Opening cgr file in SW
(OP)
I'm running SWX 2005.
I have a CATIA *.cgr file. when I try to bring it into SW it says that it failed. However, when I bring in a cgr that was exported from SWX, it comes in fine. I tried STEP and IGES from CATIA but to no avail. All I have is the cgr info. Did anyone run into this situation?
I have a CATIA *.cgr file. when I try to bring it into SW it says that it failed. However, when I bring in a cgr that was exported from SWX, it comes in fine. I tried STEP and IGES from CATIA but to no avail. All I have is the cgr info. Did anyone run into this situation?






RE: Opening cgr file in SW
See help and release notes for Import and export options available.
Regards,
Scott Baugh, CSWP
3DVision Technologies
www.3dvisiontech.com
www.scottjbaugh.com
FAQ731-376
FAQ559-716 - SW Fora Users
RE: Opening cgr file in SW
www.elysiuminc.com
Garland
Garland E. Borowski, PE
RE: Opening cgr file in SW
We sell the format works and CADCAM-e and both work very well.
Radialsoft sucks, I have access to it, but we haven't had very good results using it as well as are customers.
Regards,
Scott Baugh, CSWP
3DVision Technologies
www.3dvisiontech.com
www.scottjbaugh.com
FAQ731-376
FAQ559-716 - SW Fora Users