Wheel following a guide profile?
Wheel following a guide profile?
(OP)
hello all,
How do you get a wheel to run along a profile - in this instance a vertical profile which then starts to curve. In the assembly I can only mate the wheel to the profile of the straight or curve section.
How do i mate the wheel so that it follow the full profile path and not just the one profile surface.
Thanks in advance,
Callum
How do you get a wheel to run along a profile - in this instance a vertical profile which then starts to curve. In the assembly I can only mate the wheel to the profile of the straight or curve section.
How do i mate the wheel so that it follow the full profile path and not just the one profile surface.
Thanks in advance,
Callum






RE: Wheel following a guide profile?
Regards,
Scott Baugh, CSWP
3DVision Technologies
www.3dvisiontech.com
www.scottjbaugh.com
FAQ731-376
FAQ559-716 - SW Fora Users