2002 - ANSI -C Plts not centered
2002 - ANSI -C Plts not centered
(OP)
I am trying to plot ANSI C (17x22) dwgs to a Xerox 8830 and am finding that even when I use the center plot function in ACAD and the preview looks correct, that the plot will have slightly different margains left-right, top-bottom. Plotting the same dwg on our HP plotters it is perfectly centered.
We have had the Xerox calibrated and larger dwgs will print much closer to center.
Any ideas?
Thanks
Andy
We have had the Xerox calibrated and larger dwgs will print much closer to center.
Any ideas?
Thanks
Andy





RE: 2002 - ANSI -C Plts not centered
"Everybody is ignorant, only on different subjects." — Will Rogers
RE: 2002 - ANSI -C Plts not centered
Andy
RE: 2002 - ANSI -C Plts not centered
RE: 2002 - ANSI -C Plts not centered
"Everybody is ignorant, only on different subjects." — Will Rogers