simulation - linear motor/limit mate
simulation - linear motor/limit mate
(OP)
I've created a simple assy. I've given it a basic limit mate, and I'm trying to drive one of the parts with a linear motor. I calculate the sim and it gives me this message:
Then I run the sim and obviously nothing happens.
Do simulations not like limit mates?
Quote:
This assembly contains limit mates. These mates will be held in their current positions during Physical Simulation.
Then I run the sim and obviously nothing happens.
Do simulations not like limit mates?






RE: simulation - linear motor/limit mate
Regards,
Scott Baugh, CSWP
3DVision Technologies
www.3dvisiontech.com
www.scottjbaugh.com
FAQ731-376
FAQ559-716 - SW Fora Users
RE: simulation - linear motor/limit mate
Flores