Move Datum Origin - Drafting
Move Datum Origin - Drafting
(OP)
Using NX3 (same problem in v18)
When creating a Datum leader "Datum Feature w/ Extension Line" you are required to pick an origin point and then the datum location.
Problem is I can not move the leader origin point (can only move the datum box location).
Any help greatly appreciated,
wado
When creating a Datum leader "Datum Feature w/ Extension Line" you are required to pick an origin point and then the datum location.
Problem is I can not move the leader origin point (can only move the datum box location).
Any help greatly appreciated,
wado





RE: Move Datum Origin - Drafting
Tim Flater
Senior Designer
Enkei America, Inc.
www.enkei.com