Balloons Not Working
Balloons Not Working
(OP)
SWX 2005 SP2
I have a large drawing that I am working in. At one point in time I was able to put balloons on the drawing, I have since deleted them all. I went to put in new ballons and when I pick on a part to balloon, it just pops my arrow away. It is not in Large Assembly Mode and I don't remember changing any settings. I also tried autoballoon and that will not work either.
Any reason why this is happening?
Thanks
I have a large drawing that I am working in. At one point in time I was able to put balloons on the drawing, I have since deleted them all. I went to put in new ballons and when I pick on a part to balloon, it just pops my arrow away. It is not in Large Assembly Mode and I don't remember changing any settings. I also tried autoballoon and that will not work either.
Any reason why this is happening?
Thanks






RE: Balloons Not Working
Also, the centerlines and dowel annotations are not working either.
RE: Balloons Not Working
I had accidently froze the current layer!