Working Threads?
Working Threads?
(OP)
Let's say I have a vice (the actual assemble is a little bit different, but it works the same way). I want to be able to simulate the motion that when I trun the handle that the vice jaw will close/open. Is there a way to assemble the components that when I rotate the handle, it will do this.






RE: Working Threads?
Regards,
Scott Baugh, CSWP
3DVision Technologies
www.3dvisiontech.com
www.scottjbaugh.com
FAQ731-376
FAQ559-716 - SW Fora Users
RE: Working Threads?
"I think there is a world market for maybe five computers."
Thomas Watson, chairman of IBM, 1943.
Have you read FAQ731-376 to make the best use of Eng-Tips Forums?