"FAILED TO SAVE" ISSUE
"FAILED TO SAVE" ISSUE
(OP)
I am working in an assembly and creating ribs in a part that is within that assembly . When I go to save the assembly after making the ribs, the window asks to save all referenced documents as well.... I say yes.... Another window pops up, "failed to save".
But if I open up the individual part and make the ribs it saves fine.
Can anyone shed any light why this happens?
Thanks.
But if I open up the individual part and make the ribs it saves fine.
Can anyone shed any light why this happens?
Thanks.






RE: "FAILED TO SAVE" ISSUE
Regards,
Scott Baugh, CSWP
3DVision Technologies
www.3dvisiontech.com
www.scottjbaugh.com
FAQ731-376
FAQ559-716 - SW Fora Users
RE: "FAILED TO SAVE" ISSUE
RE: "FAILED TO SAVE" ISSUE
I did try saving it... a few times...all failed to save. I had been working with this assembly for a while, saving all along, with no problems. It was just after creating the ribs that the assembly failed to save. Something about those ribs the assembly didn't like. I went ahead and created the ribs at the part level... it rebuilt fine when I went back into the assembly.