Assembly model varients
Assembly model varients
(OP)
Hi,
Does anyone know if it is possible to have different versions of the same assembly.
I have a pneumatic cylinder, which has an open and closed position.
I would like to make sure that the extremes do not clash on any of my design.
I have created two constraints in the cylinder model and have to repeatidly go into the model to suppress and unsuppress the correct mates, which is become a little tedious.
Thanks
Ho
Does anyone know if it is possible to have different versions of the same assembly.
I have a pneumatic cylinder, which has an open and closed position.
I would like to make sure that the extremes do not clash on any of my design.
I have created two constraints in the cylinder model and have to repeatidly go into the model to suppress and unsuppress the correct mates, which is become a little tedious.
Thanks
Ho





RE: Assembly model varients
Sean Dotson, PE
www.sdotson.com
www.mCADForums.com
CAD Professionals & Consultants Discussion
RE: Assembly model varients
Looks as if I will have to struggle on until we upgrade.
Thanks
RE: Assembly model varients
Sean Dotson, PE
www.sdotson.com
www.mCADForums.com
CAD Professionals & Consultants Discussion