Section Views
Section Views
(OP)

I have a drawing that is going to have eight to twelve pages when I get through the assembly drawing. I want have a section call-out on page one and have section view show on page three and four, and etc. When I press the section view button, I draw the line and etc. but it attaches it to first page, I already have enough stuff on the first page I would like to place the section view that I made on a different sheet, is this at all possible ?






RE: Section Views
All you have to do is drop the section view on the current page. Once you have created the section view go to Edit,Cut and select the page you want your section view and Edit, Paste. That's all there is to it.
Scorch
RE: Section Views
laelow