Is 2D possible with Inventor or SolidWorks?
Is 2D possible with Inventor or SolidWorks?
(OP)
I presently use Bentley's MicroStation J. I am very content using J for my 2D plant layout functions. Corporate wants all to use the same software for all 3D and 2D applications (SW or Autodesk Inventor). I believe it's possible for all 3D apps, but what about 2D? Any experience?






RE: Is 2D possible with Inventor or SolidWorks?
DimensionalSolutions@Core.com
While I welcome e-mail messages, please post all thread activity in these forums for the benefit of all members.
RE: Is 2D possible with Inventor or SolidWorks?
Check out www.midrangecad.com
Don
Don Shoebridge
Dayton, Ohio
The birthplace of aviation
Check out my webpage
www.geocities.com/donshoebridge
RE: Is 2D possible with Inventor or SolidWorks?
Don, I looked your web page, you and I have several hobbies(passions) in common. I was looking for an email link to send you a comment or two but I didn't see one on your site
Regards
Jon
RE: Is 2D possible with Inventor or SolidWorks?
No e-mail address?!?!?! I'll take care of that little problem. My e-mail address is donshoebridge@yahoo.com. Kind of tough to forget this way.
Don Shoebridge
Sr. Product Developement Engineer
www.geocities.com/donshoebridge