Seeking best finishing process for 303SS shaft...
Seeking best finishing process for 303SS shaft...
(OP)
Hi All,
We're seeking the most suitable finishing process that will produce an 8uIN finish (for use with a Variseal) on a .154/.152 diameter x 4.00" long 303 SS precision ground shaft (e.g. McMaster Carr # 88915K42). I've been told: electro plate, electropolish and chrome plate. Any validity to these?
Thanks in advance...
We're seeking the most suitable finishing process that will produce an 8uIN finish (for use with a Variseal) on a .154/.152 diameter x 4.00" long 303 SS precision ground shaft (e.g. McMaster Carr # 88915K42). I've been told: electro plate, electropolish and chrome plate. Any validity to these?
Thanks in advance...





RE: Seeking best finishing process for 303SS shaft...
Robert Setree
www.advanced-grinding.com
RE: Seeking best finishing process for 303SS shaft...
http://www.bostoncenterless.com/stainless.htm
RE: Seeking best finishing process for 303SS shaft...
I seen these peoples’ work and it is very good. I would contact them and see if it is feasible to micro finish a part your size.
http://www.impco.com/Microfinishing.htm