contour milling plunge points(nx3)
contour milling plunge points(nx3)
(OP)
Could someone please tell me if there is an easy way to plunge in the CENTER of multiple closed circles, ie. spring pockets or counterbores, on one process.
For example, I want to mill the contour of 5 spring pockets,and plunge in the center of each pocket, the program only recognizes the 1st pocket, and wants to start at that center for each pocket after that.
For example, I want to mill the contour of 5 spring pockets,and plunge in the center of each pocket, the program only recognizes the 1st pocket, and wants to start at that center for each pocket after that.




