how to re-open a file in memory which is "not displayed"?
how to re-open a file in memory which is "not displayed"?
(OP)
Could anyone tell me how to open a part or dwg which is closed but still in memory?
I have no way but go file/erase/not displayed, then re-open that file from computer folder. I think this is a sutpid way as it takes a lot of time.
Thanks!
I have no way but go file/erase/not displayed, then re-open that file from computer folder. I think this is a sutpid way as it takes a lot of time.
Thanks!





RE: how to re-open a file in memory which is "not displayed"?
Hope this is what you need!
RE: how to re-open a file in memory which is "not displayed"?