SolidWorks - How to bend already bended detail
SolidWorks - How to bend already bended detail
(OP)
I have sheet metal part that already have many bends (this detail have fluted surface). Now I need to bend this detail to new profile in perpendicular direction to other bends. This is part of culvert.
How I can do this? If my explanation not enough understanable I can send scheme to specialist.
How I can do this? If my explanation not enough understanable I can send scheme to specialist.






RE: SolidWorks - How to bend already bended detail
You could produce the part using regular SW features,(sweeps, lofts, etc) but you will not have the "flatten" functionality of a SM part.