Unigraphics NX2_layer control etc.
Unigraphics NX2_layer control etc.
(OP)
Hi,
I have found that when I open the layer control on Unigraphics NX2 the bottom part of the menu is off the screen and I cannot confirm any settings etc. Anybody got any ideas on this one?
Regards
I have found that when I open the layer control on Unigraphics NX2 the bottom part of the menu is off the screen and I cannot confirm any settings etc. Anybody got any ideas on this one?
Regards





RE: Unigraphics NX2_layer control etc.
RE: Unigraphics NX2_layer control etc.
UG_categoryListItems: 10
UG_layerListItems: 23
These have a maximum, when added together, of 33 on a 19" monitor and 17 on a 17".
"Wildfires are dangerous, hard to control, and economically catastrophic."
"Fixed in the next release" should replace "Product First" as the PTC slogan.
Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand