Taper issue
Taper issue
(OP)
I am using taper, using the edge option. Well I pick my die pull and it fails. When I preview the faces it highlights the face normal to the surface I need tapered. How do you designate the other surface using the taper along and edge option.
I can not use taper the face due to compound angle.
Thanks.
I can not use taper the face due to compound angle.
Thanks.
Ross Parpart
Product Design Engineer
www.decoma.com





RE: Taper issue
Tim Flater
Senior Designer
Enkei America, Inc.
www.enkei.com
RE: Taper issue
The UGS bbsnotes page allows this if you have a vaild webkey account.
Tim Flater
Senior Designer
Enkei America, Inc.
www.enkei.com
RE: Taper issue
Ross Parpart
Product Design Engineer
www.decoma.com
RE: Taper issue
Tim Flater
Senior Designer
Enkei America, Inc.
www.enkei.com
RE: Taper issue