Need advice on assembling rubber grommet to cylinder
Need advice on assembling rubber grommet to cylinder
(OP)
I am new to Inventor and would like some advice on an easy way to set up a rubber grommet to assemble to the wall of a cylinder. These thin walled cylinders come in a variety of diameters and the holes vary in location. The flexible grommets must take on the radius of the cylinder that they are assembled to. I couldn't find anything similar to this in the documentation that I have read so far. I would appreciate any help that you could provide.
Slipree
Slipree





RE: Need advice on assembling rubber grommet to cylinder
Sean Dotson, PE
www.sdotson.com
www.mCADForums.com
CAD Professionals & Consultants Discussion